direkt zum Inhalt springen

direkt zum Hauptnavigationsmenü

Sie sind hier

TU Berlin

Page Content


Investigation of Film Cooling in Unsteady Flow with Separation Bubble
Citation key deinert_m_diss_2006_en
Author Michaela Deinert
Year 2006
DOI 10.14279/depositonce-1306
Location Berlin
Month March
Note DGLR/Airbus Nachwuchspreis für eine herausragende Dissertation
Editor DepositOnce - Institutional Repository for Research Data and Publications of TU Berlin
How Published In Copyright: http://rightsstatements.org/vocab/InC/1.0/
School Technische Universität Berlin
Abstract This study gives a detailed evaluation of film cooling characteristics in unsteady flow with a separation bubble. The investigation was carried out on a flat plate with superimposed pressure distribution typical of turbine blading. A contoured wall opposite a flat plate generates this pressure distribution with a strong adverse pressure gradient, which induces a separation bubble in the middle of the plate. The main objective is to investigate the influence of the separation bubble on the cooling air flow, the flow field and different film cooling parameters under periodically unsteady flow conditions. Therefore measurements were conducted in an open-circuit, low-speed, suction-type wind tunnel, which can generate periodically pulsating flow. Measurements of the flow velocity and temperature using hot and cold wire anemometry for different boundary conditions were carried out, as well as measurements of the surface temperature using the infrared therography. Experimental data are supported by numerical calculations. The flat plate is 1000 mm in length and has a width of 400 mm. The cooling air enters the test section through a row of 7 cylindrical film-cooling holes with sharp edges and an inclination angle of 35 degrees. The film cooling holes, which are 8 mm in diameter and have a pitch to diameter ratio of 3:1, are located in the middle of the flat plate. The results show that the periodic changes of size and shape of the separation bubble in a film cooled flow field under unsteady flow conditions are still dominated by the superimposed periodically changing pressure distribution. The incoming cooling air influences the separation bubble in two ways. On the one hand, the separation bubble is displaced by the film cooling jet, which means that it is only present upstream of the air injection point and on the other hand the separation bubble is thicker directly in front of the incoming film cooling jet because of the superimposed pressure field upstream of the jet. The results of flow temperature measurements show a small low-temperature area upstream of the film cooling jet at the position of the separation bubble. It was shown that cooling air flows upstream into the separation bubble developing this cooled area. This phanomenon occurs in steady and unsteady flow.
Link to publication Link to original publication Download Bibtex entry

Zusatzinformationen / Extras

Quick Access:

Schnellnavigation zur Seite über Nummerneingabe

This site uses Matomo for anonymized webanalysis. Visit Data Privacy for more information and opt-out options.